Bill Hunt wrote:
Bill, what is "Cut on Zero-Crossings"? Sounds interesting!
When Cutting Audio, clicks and pops can develop if the Cut is made, where the Waveform is NOT at the Zero-point, i.e. where it crosses the Zero line. In Audition, one can limit all Cuts TO a Zero-Crossing Point. For a bit more detail, this article might prove useful: http://forums.adobe.com/message/3365894#3365894
One can change the Display in PrPro to Audio Units, and then carefully place a cut at the Zero-Crossing point with some accuracy, but in Audition, with Cut at Zero-Crossings ON, the Cut will naturally move to the nearest Zero-Crossing accurately. With the high Sample-Rate, finding a good Zero-Crossing will only alter the Cut by a ms, or two.
Hope that helps,
Hunt
Oh hell yeah, that would be nice! Feature Request, done. Thanks Bill!